Multiple Spanning Tree Protocol Port Configuration - ZyXEL Communications XS1930-12F User Manual

Table 66 Advanced Application > Spanning Tree Protocol > MSTP (continued)
LABEL
Path Cost
Add
Cancel
Instance
VLAN
Active Port
Delete
Cancel

13.6.1 Multiple Spanning Tree Protocol Port Configuration

Click Advanced Application > Spanning Tree Protocol > MSTP > Port in the navigation panel to display
the status screen as shown next.
Figure 111 Advanced Application > Spanning Tree Protocol > MSTP > Port
The following table describes the labels in this screen.
Table 67 Advanced Application > Spanning Tree Protocol > MSTP > Port
LABEL
MSTP
Port
Chapter 13 Spanning Tree Protocol
DESCRIPTION
Path cost is the cost of transmitting a frame on to a LAN through that port. It is recommended
to assign this value according to the speed of the bridge. The slower the media, the higher the
cost.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses this change if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the ID of an MST instance.
This field displays the VID (or VID ranges) to which the MST instance is mapped.
This field display the ports configured to participate in the MST instance.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Check the rules that you want to remove and then click the Delete button.
Click Cancel to clear the selected check boxes.
DESCRIPTION
Click MSTP to edit MSTP settings on the Switch.
This field displays the port number. * means all ports.
XS1930 Series User's Guide
149