Table of Contents
Advertisement
SECTION 5: ADJUSTMENTS
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
G9933 Three Spindle Shaper
Keep clothing rolled up
and out of the way of
machinery
and
keep
hair pulled back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.
Pulleys & V-Belts
Improper pulley alignment sharply reduces the
effectiveness of power transmission and belt life
expectancy. To align the pulleys:
1.
Open the motor covers on the back of the
shaper cabinet to expose the motor and pul-
leys.
2.
Check the alignment of each with a straight-
edge. If the pulleys are in alignment, the
straightedge should touch two sides of each
pulley evenly.
3.
If pulleys are not in-line, loosen the motor
mount plate bolts shown in Figure 7, and
slide the motor up or down until the pulleys
are in line. To make this easier, use a bottle
jack to help in moving the motor up and
down or get help from a friend.
Figure 7. Motor plate bolts.
4.
Tighten the motor plate bolts to secure the
motor after the pulleys are aligned.
-11-
Advertisement
Table of Contents
