Guard Assembly; Power Cord - Grizzly G9933 Instruction Manual

Guard Assemblies
The Model G9933 comes with a guard assembly
for each of the 3 spindles. These come assem-
bled complete with hold downs and fences. The
only set-up required is fastening them to the
table. To fasten the guard assemblies to the
table:
1.
Slide the dust port on the back of the guard
assembly into the dust port adapter.
2. Line up the slots on the guard assembly with
the four closest holes to the spindle, and fas-
ten the assembly to the table as shown in
Figure 6.
Figure 6. Fastening guard assembly to table.
3. Repeat Steps 1 & 2 with the other two guard
assemblies.
-10-

Power Cord

To connect a power cord to your Model G9933:
1. Locate the electrical box near the base of the
shaper.
2. Remove the two hex nuts and washers that
secure the cover on the electrical box.
3. Pull your power cord through the strain relief
on the electrical box cover.
4. Mirror the existing wires that are already
connected to the terminal. The smallest wire
(green) is the ground. Make sure the ground
from your power cord is across from the
ground wire on the shaper.
5. Insert each wire as shown on Figure 6A and
tighten the respective screws on the face of
the terminal block. The wires should now be
secure in each terminal. Give them a quick
test by tugging each one with mild pressure.
Do not pull too hard.
Shaper
Hot
Hot
Power Cord
Figure 6A. Connecting power cord to terminal block.
6. Place the cover back over the terminal block
and secure it with the two washers and hex
nuts. Tighten the strain relief to the power
cord. See Section 2: Circuit Requirements
for plug information.
Ground
Hot
Hot
Ground
G9933 Three Spindle Shaper