V-Belt Tension; Cutterhead Opening - Grizzly G9933 Instruction Manual

V-Belt Tension

The V-belts are small and run very fast; therefore,
the ideal deflection is
pressure. The V-belts will slip if too loose, and will
squeal or cause vibration if too tight. Only adjust
the tension if necessary. To adjust one of the V-
belts:
1. Make sure the pulleys are properly aligned,
then loosen the hinge bolts that allow the
motor to swing toward and away from the
spindle pulley.
2. Adjust the position of the motor so it is either
closer or farther away than the spindle pul-
ley, depending on if the V-belt was either too
loose or too tight.
3. Tighten the hinge bolts and test the tension.
4. Repeat steps 1-3 until the tension is correct.
-12-
1 ⁄ " with moderate finger
4

Cutterhead Opening

The fence rails can be mounted on the fence
pieces in two ways. Figure 9 shows the incorrect
and correct way the rails should be mounted.
Incorrect
Correct
Figure 9. Correct fence rail position.
The correct position will allow the cutterhead
opening to travel from 0"-5
turned around or incorrect, the opening will
be restricted to 0"-3".
G9933 Three Spindle Shaper
5 ⁄ ". If the rail is
8