Grizzly G9933 Instruction Manual page 23

4. Set the right and left wood face ends to
barely clear the cutter. This allows the max-
imum support possible. Remember to tight-
en down the wood facing before starting the
shaper.
5. When removing the entire face of the work-
piece, a test sample of the desired cut
should be advanced about 8'' then stopped.
6. Once the shaper is turned off and the cutter
has come to a complete stop, adjust the
outfeed fence to support the new profiled
edge as shown in Figure 21.
Figure 21. Fence adjusted to support workpiece.
If the face of the workpiece will only be partially
removed, observe the following steps:
1. Adjust the infeed fence to approximately
the desired depth of cut. Lock the infeed
fence in place.
2. Use a straightedge to adjust the outfeed
fence to the same plane as the infeed. Lock
the outfeed fence in place.
3. Set the right and left wood face ends so
they barely clear the cutter. This allows the
maximum support possible for the work-
piece. Remember to tighten down the wood
facing before starting the shaper.
G9933 Three Spindle Shaper
4. Run a test piece through the shaper as
shown in Figure 22.
Figure 22. Fence adjustment for blind cuts.
5. Always cut the end grain first when putting
an edge around the perimeter of your work-
piece. See Figure 23.
Figure 23. Sequence for multiple cuts.
-21-