Table of Contents
Advertisement
SECTION 5: ADJUSTMENTS
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Speed Changes
The Model G9862/G9968 Shaper is equipped
with three groove pulleys that control the speed of
the spindle. To change spindle speeds:
1.
Unplug the machine.
2.
Turn the belt tensioning lever (shown in
Figure 9) counterclockwise to loosen the
adjustment bracket.
3.
Pull the motor toward the spindle pulley to
loosen the V-belt.
-14-
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.
Figure 9. Belt tensioning lever.
4.
Select the desired speed. There are three
speeds for the spindle: 5500, 7500 and
10,000 R.P.M. Figure 10 shows the belt
position for each available speed.
Figure 10. Spindle speed adjustment.
5.
Align the belt along the appropriate pulley
groove.
6.
Swing the motor away from the spindle pul-
ley so the belt is tight.
7.
Tighten the belt tensioning lever.
8.
Spin the pulley to ensure proper tracking.
G9862/G9968 Shaper
Advertisement
Table of Contents
