Table of Contents
Advertisement
SECTION 6: OPERATIONS
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Always wear a dust mask
when
shaper.
machine produces saw-
dust which may cause
allergic reactions or res-
piratory problems.
NOTICE
The following section was designed to give
instructions on the basic operations of this
shaper. However, it is in no way compre-
hensive of every shaper application. There
are many different jigs that can be built to
increase safety, accuracy, and types of
cuts. WE STRONGLY RECOMMEND that
you read books, trade magazines, or get for-
mal training to maximize the potential of
your shaper.
G9862/G9968 Shaper
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing all operations on the
shaper. Failure to com-
ply may result in serious
personal injury.
operating
Using
Your shaper is equipped with a START/STOP
switch as shown in Figure 18. Always feed the
workpiece against the rotation of the cutter.
Whenever possible, mount the cutter so the
board is milled on the bottom side. This method
does a better job, and it is safer for the operator.
Always check the direction of cutter rota-
tion before beginning any shaping opera-
tion.
the
this
Switch
Figure 18. ON/OFF switches.
-19-
Advertisement
Table of Contents
