Table of Contents
Advertisement
Reverse Switch
Your
shaper
is
FORWARD/REVERSE switch as shown in
Figure 18A. In many instances, it will be neces-
sary to flip the cutter over and reverse cutter rota-
tion. Whenever possible, mount the cutter so the
board is milled on the bottom side. This does a
better job, and it is safer for the operator.
Always check the direction of cutter rota-
tion before beginning any shaping opera-
tion.
-20-
equipped
with
a
Figure 18A. Forward/reverse switch.
This machine was designed to be started
and stopped with the START/STOP but-
tons—not the reversing switch.
NOTICE
G9862/G9968 Shaper
Advertisement
Table of Contents
