Adjustments; G1022Sm Fence - Grizzly G1022PRO Instruction Manual

SECTION 5: ADJUSTMENTS
!
Disconnect power to the
machine when perform-
ing any maintenance,
assembly
ments. Failure to do this
may result in serious
personal injury.
G1022 Series Contractor Saws
or adjust-
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses
during the entire adjust-
ment process. Failure to
comply may result in
serious personal injury.

G1022SM Fence

(The Model G1022ZF, ZFX and PRO use a Shop
®
Fox fences. Please refer to the instruction man-
ual included with the Shop Fox
plete directions on adjusting.)
The fence must engage and square up on the
front rail before the rear clamp engages the back
rail. In essence, the rear clamp should act as a
secondary mechanism for maintaining fence
position. When adjusted correctly, the lever lock
should only begin to apply pressure on the back
rail over the last one-third of its stroke. To adjust
the fence:
1. First, make sure the front clamp is engaging
the front rail with the lock handle at one-half
of its throw. If the front clamp requires adjust-
ment, loosen the check nut shown in Figure
32. Turn the adjusting bolt clockwise if the
front clamp is too far from the rail, or counter-
clockwise if it is too close.
Adjusting Bolt
Figure 32. Adjusting clamp mechanism.
2. Now slide the fence along the rail until it is
aligned with the edge of the miter slot. Lock
the fence down.
®
fences for com-
Check Nut
-27-