Fence; Blade - Grizzly G1022PRO Instruction Manual

Figure 22. Attaching fence rails.

Fence

G1022SM and G1022Z
1. Thread the plastic knob onto the lock handle.
2. Set the lock handle in the up position and
slide the fence over the front and rear rails as
shown in Figure 23.
Figure 23. G1022SM fence shown.
3. The fence will require further adjustments, all
of which are covered in Adjustments
Section.
G1022 Series Contractor Saws
Lock Handle

Blade

Please refer to our current catalog for a complete
selection of saw blades. To install the saw blade:
1. Unthread the arbor nut clockwise and
remove the outside flange from the arbor.
Note that there is a
the arbor shaft. Remove and discard it.
Remember the arbor nut is a left-handed
thread.
2. Install the saw blade onto the arbor. Ensure
that the blade teeth point toward you as you
stand at the front of the saw. Slide on the
flange and thread the arbor nut back on.
3. Use the arbor wrench provided with the saw
to tighten the arbor nut. Wedge a block of
wood in the teeth of the blade to keep it from
turning when tightening the nut as shown in
Figure 24.
Figure 24. Changing saw blade.
!
Disconnect power to the
machine when perform-
ing any maintenance,
assembly
ments. Failure to do this
may result in serious
personal injury.
3
⁄ '' diameter spacer on
4
or adjust-
-23-