Table of Contents
Advertisement
Chapter 2 Description of parts — Power supply and accessory mounting section
Power supply and accessory mounting section
11
1
1 <POWER> switch (page 54)
Switch on/off the power.
@
NOTE
t Even when the <POWER> switch is set to the <OFF> position, the camera is not shut off from the main power.
2 Battery release lever (page 28)
Pull this battery release lever down to release the battery.
3 Battery holder (page 28)
Mount the Anton/Bauer battery.
4 Light control switch (page 28)
5 <DC IN> terminal (page 29)
This is the external DC power supply input terminal. Connect to the external DC power supply.
6 <DC OUT> terminal (page 41)
This is the DC 12 V output terminal. It provides a maximum current of 1.5 A.
@
NOTE
t When connecting external equipment to this terminal, first fully check the polarities of the connection. Failure to do so may result in a malfunction.
7 <REMOTE> terminal (pages 184, 186)
Connect the remote control unit AJ-RC10G (optional) to remote-control some functions. For details, refer to "Connecting to the remote control unit
(AJ-RC10G)" (page 184).
Connect the extension control unit AG-EC4G (optional) to remote-control some functions. For details, refer to "Connecting to the extension control
unit (AG-EC4G)" (page 186).
8 Light output terminal
Connect the Ultralight 2 of Anton/Bauer (optional) or an equivalent video light of 50 W or under.
The battery charge level drops sharply when the light is illuminated. When using the light, using a battery of 90 Wh or more is recommended.
9 Cable holders
Used for clamping the light and microphone cables in place.
10 Accessory mounting holes
Attach accessories. Use only for the purpose of attaching accessories.
f Mounting hole size
- 1/4-20 UNC (screw length 10 mm or shorter)
- 3/8-16 UNC (screw length 10 mm or shorter)
11 Shoulder strap attachment fitting (page 39)
Attach the shoulder strap.
12 Light shoe
Attach the video light.
Mounting hole size
f 1/4-20 UNC (screw length 6 mm or shorter)
13 Viewfinder left-right positioning ring
To adjust the left/right position of the viewfinder, loosen this ring, and slide the viewfinder to the left or right to adjust it to an easy-to-view position.
Tighten the ring to clamp the viewfinder in place after adjusting the viewfinder.
14 <VF> terminal
Attach the viewfinder AG-CVF15G (optional), etc.
2
3
4
5 6
7
– 15 –
9
10
8
15
11
12
13
14
16
17
18
19
20
Advertisement
Table of Contents
