Table of Contents
Advertisement
Audio (input) function section
1 <MIC IN> terminal (page 37)
Connect the microphone (optional).
f The phantom microphone can also be used. To use this, set [ON] in the main menu → [AUDIO SETUP] → [INPUT SETTING] → [FRONT MIC
POWER]. When it is set to [ON] and a microphone is not connected, low frequency noise may occur. This is not a problem when a microphone is
connected.
2 <F.AUDIO LEVEL> dial (page 69)
Adjust the recording level of audio channels 1 to 4.
f Setting the audio level adjustment method to [MANU] on the [AUD02:INPUT] screen of SmartUI allows you to adjust the audio level of the voice
channel using this dial.
f You can use the main menu → [AUDIO SETUP] → [RECORDING CH SETTING] → [FRONT VR CH1], [FRONT VR CH2], [FRONT VR CH3], and
[FRONT VR CH4] to set the controls so that this operation can be done from any input terminal.
3 <AUDIO IN CH1/3>, <AUDIO IN CH2/4> terminal (page 38)
Connect the audio equipment or the microphone.
4 <LINE>/<MIC> switch (pages 38, 45)
Switch audio input signals connected to the <AUDIO IN CH1/3>/<AUDIO IN CH2/4> terminal.
<LINE>: Select when audio equipment is connected by the line input.
<MIC>: Select when the external microphone is connected.
5 Microphone input power switch (page 45)
Switch to supply power to the microphones connected to <AUDIO IN CH1/3> and <AUDIO IN CH2/4> terminals.
<+48V>: Supplies +48 V power to the microphone.
<OFF>: Does not supply power to the microphone.
@
NOTE
t When microphone input <+48V> is set and microphones are not connected to the <AUDIO IN CH1/3> and <AUDIO IN CH2/4> terminals, low-
frequency noise may occur. This is not a problem when a microphone is connected.
6 Wireless slot (page 37)
Mount the UniSlot wireless microphone receiver (optional).
Chapter 2 Description of parts — Audio (input) function section
1
2
– 17 –
6
4
3
5
Advertisement
Table of Contents
