Power Supply And Accessory Mounting Section - Panasonic AJ-PX800G Operating Instructions Manual

Chapter 2 Description of parts — Power supply and accessory mounting section

Power supply and accessory mounting section

11
1
1 <POWER> switch (page 48)
Switch on/off the power.
2 Battery release lever (page 27)
Pull this battery release lever down to release the battery.
3 Battery holder (page 27)
Mount the Anton/Bauer battery.
4 Light control switch (page 27)
5 <DC IN> terminal (page 28)
This is the external DC power supply input terminal. Connect to the external DC power supply.
6 <DC OUT> terminal (page 40)
This is the DC 12 V output terminal. It provides a maximum current of 1.5 A.
@
NOTE
t When connecting external equipment to this terminal, irst fully check the polarities of the connection. Failure to do so may result in a malfunction.
7 <REMOTE> terminal (pages 169, 171)
Connect the remote control unit AJ-RC10G (optional) to remote-control some functions. For details, refer to "Connecting to the remote control unit
(AJ-RC10G)" (page 169).
Connect the extension control unit AG-EC4G (optional) to remote-control some functions. For details, refer to "Connecting to the extension control
unit (AG-EC4G)" (page 171).
8 Light output terminal
Connect the Ultralight 2 of Anton/Bauer (optional) or an equivalent video light of 50 W or under.
The battery charge level drops sharply when the light is illuminated. When using the light, using a battery of 90 Wh or more is recommended.
9 Cable holders
Used for clamping the light and microphone cables in place.
10 Accessory mounting holes
Attach accessories. Use only for the purpose of attaching accessories.
f Mounting hole size
- 1/4-20 UNC (screw length 10 mm or shorter)
- 3/8-16 UNC (screw length 10 mm or shorter)
11 Shoulder strap attachment itting (page 38)
Attach the shoulder strap.
12 Light shoe
Attach the video light.
Mounting hole size
f 1/4-20 UNC (screw length 6 mm or shorter)
13 Viewinder left-right positioning ring
To adjust the left/right position of the viewinder, loosen this ring, and slide the viewinder to the left or right to adjust it to an easy-to-view position.
Tighten the ring to clamp the viewinder in place after adjusting the viewinder.
14 <VF> terminal
Attach the viewinder AG-CVF15G (optional), etc.
15 Lens cable/microphone cable clamp (page 30)
Used for securing the lens and microphone cables.
2
3
4
5 6 7
– 15 –
9 10
8
15
11 12 13
14
16 17 18 19 20