Installing The Mini Perc Card Air Shroud - Dell EMC PowerEdge R7515 Installation And Service Manual

Figure 106. Removing the mini PERC card air shroud
2. Remove the air shroud from the system.
Next steps
1. Replace the PERC card air

Installing the mini PERC card air shroud

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. If applicable, remove the rear drive
5. If applicable, remove the expansion card
Steps
1. Align the mini PERC card air shroud with the screw hole on the system board.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud until it is firmly seated.
3. Tighten the screw to secure the mini PERC card air shroud to the system board.
100 Installing and removing system components
shroud.
Safety instructions
Before working inside your system
cage.
riser.
on page 26.
on page 27.