Installing The Rear Drive Cage - Dell EMC PowerEdge R7515 Installation And Service Manual

Figure 53. Removing the rear drive cage
Next steps
1. Replace the rear drive

Installing the rear drive cage

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drives.
Steps
1. Align the rear drive cage with the guide pins on the PSU cage.
2. Lower the rear drive cage and slide it to the rear of the system until it is firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws to secure the rear drive cage to the system.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
cage.
Safety instructions
Before working inside your system
on page 26.
on page 27.
Installing and removing system components 55