b. Using a Phillips #2 screwdriver, secure the LOM filler bracket to the chassis with a screw
Figure 102. Installing the LOM filler bracket
Next steps
1.
Replace the LOM riser
Installing the LOM riser card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the rear drive
5.
Remove the expansion card
Steps
1. Remove the LOM filler bracket.
a. Using a Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
b. Slide the LOM filler bracket out of the slot on the chassis.
card.
Safety instructions
Before working inside your system
cage.
riser.
on page 26.
on page 27.
Installing and removing system components
97