Figure 95. Installing the M.2 SSD module
Next steps
1.
Install the BOSS card
NOTE:
The procedure to install the BOSS card is similar to removing an expansion card.
2.
Install expansion card riser
3.
Install the air
shroud.
4. Follow the procedure listed in
Optional IDSDM module
Removing the IDSDM card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If you are replacing the IDSDM card,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
NOTE:
There are two dip switches on the IDSDM card for write-protection.
into the riser.
After working inside your system
Safety instructions
Before working inside your system
remove the MicroSD
on page 27.
on page 26.
on page 27.
cards.
Installing and removing system components
91