Installing Idsdm Card - Dell EMC PowerEdge R7515 Installation And Service Manual

Figure 96. Removing the IDSDM card
Next steps
NOTE: If you are replacing the IDSDM module, remove the MicroSD cards.
1. Replace the IDSDM module.

Installing IDSDM card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. If you are replacing the IDSDM card,
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
1. Locate the IDSDM connector on the system board. To locate IDSDM connector, see
section.
2. Align the IDSDM card with the connector on the system board.
3. Push the IDSDM card until it is firmly seated on the system board.
92 Installing and removing system components
Safety instructions
Before working inside your system
remove the MicroSD cards.
on page 26.
on page 27.
System board jumpers and connectors