Removal And Replacement Of Parts; Covers And Panels - Vulcan-Hart VC5E Service Manual

VC5ED FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS

REMOVAL AND REPLACEMENT OF PARTS

COVERS AND PANELS

electrical power to the machine and
follow lockout / tagout procedures.
Bottom Front Cover
1. Remove four screws, two from each side of
bottom cover, then remove cover from oven.
Fig. 1
2. Reverse procedure to install. Verify bottom cover
is seated under front plate.
Fig. 2
Right Side - Front Panel
electrical power to the machine and
follow lockout / tagout procedures.
1. Loosen two screws near front of oven, which
secure bottom front cover.
2. Loosen screws on left side of front panel and top
cover screw.
Disconnect the
Disconnect the
Page 5 of 31
3. Remove screws along right side and bottom of
front panel.
Fig. 3
4. Slide right side front panel out.
5. Reverse procedure to install.
Right Side - Rear Panel
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove two middle screws along right side of
rear panel.
2. Remove screws along left side of rear panel.
3. Remove bottom screws on rear panel.
4. Loosen top and bottom screw along right side of
rear panel.
Disconnect the
F45652 (0217)