Advertisement
Contents
Connections
Setting the Remote ID
When using multiple Denon AV receivers in the same room, make this
setting so that only the desired AV receiver operates.
The default setting is "ID-1".
0
1
Press and hold RC SETUP for more than 3 seconds.
"SETUP" and p indicator flashes twice on the remote control unit.
2
Use ui to display "RC-ID" on the remote control unit
and press ENTER.
3
Use ui to set the remote ID and press ENTER.
"OK" flashes four times on the remote control unit and the normal
operation mode is restored.
Remote control unit display
ID-1
ID-2
ID-3
ID-4
NOTE
0 When you change the remote ID, make sure that the remote control unit and the
remote ID of the main unit are exactly the same. (v p. 280)
Front panel
Display
Playback
Settings
Setting the display time length of the
remote control unit display
Use the following procedure to set the length of time for which to display
data such as zone and mode on the display panel of the remote control
unit.
The default setting is "05SEC".
0
1
2
3
Remote ID
1
2
3
4
298
Rear panel
Tips
Press and hold RC SETUP for more than 3 seconds.
"SETUP" and p indicator flashes twice on the remote control unit.
Use ui to display "DISPL" on the remote control unit
and press ENTER.
Use ui to set the display time length and press
ENTER.
"OK" flashes four times on the remote control unit and the normal
operation mode is restored.
Remote control unit display
05SEC
10SEC
15SEC
Remote
Index
Appendix
Display time
5 sec
10 sec
15 sec
Advertisement
