Contents
Connections
Q3
Q4
Q5
Q6
M SIGNAL GND terminal
Used to connect a ground wire for the turntable. (v p. 93)
N TRIGGER OUT jacks
Used to connect devices equipped with the trigger function.
(v p. 101)
O REMOTE CONTROL jacks
Used to connect infrared receivers/transmitters in order to operate this
unit and external devices from a different room. (v p. 100)
Front panel
Display
Playback
Q7
Q8
Rear panel
Settings
P RS-232C connector
Used to connect home automation controller devices fitted with
RS-232C connectors. Consult the owner's manual of the home
automation controller for more information about serial control of this
unit.
Perform the operation below beforehand.
A Turn on the power of this unit.
B Turn off the power of this unit from the external controller.
C Check that the unit is in the standby mode.
Q Digital audio connectors (DIGITAL AUDIO)
Used to connect devices equipped with digital audio connectors.
"Connection 2 : TV equipped with an HDMI connector and
0
incompatible with the ARC (Audio Return Channel) / eARC
(Enhanced Audio Return Channel)" (v p. 85)
"Connection 3 : TV equipped without an HDMI
0
connector" (v p. 86)
"Connecting a set-top box (Satellite tuner/cable TV)" (v p. 88)
0
"Connecting a DVD player or Blu-ray Disc player" (v p. 89)
0
R Speaker terminals (SPEAKERS)
Used to connect speakers. (v p. 43)
NOTE
0 Do not touch the inner pins of the connectors on the rear panel. Electrostatic
discharge may cause permanent damage to the unit.
28
Remote
Tips
Appendix
Index