Omron PROFINET IO CJ1W-PRM21 Operation Manual page 44

Installation of Configuration Software
Updating the Device
Catalogue
Note
3-5-3 GSDML Files support
3-5-3-1 Installation procedure
28
Pressing the Next button will start the installation.
4 When done, the installation program will notify the user of its completion.
The update of the Device Catalogue of the FDT Container is required.
After installation of the CJ1W-PNT21 DTM the Device Catalogue in the FDT
Container needs to be updated, to show the new CJ1W-PNT21 DTM in the list
of available devices. For CX-ConfiguratorFDT the following procedure applies.
1,2,3... 1 Open the Device Catalogue window in CX-ConfiguratorFDT.
2 Press the Update button to initiate the update sequence.
After updating, the CJ1W-PNT21 DTM will be shown in the list of available
devices. It can now be used to setup a PROFINET IO network and configure
the PROFINET IO Controller Unit.
In case the required PROFINET IO Controller DTM has not been installed, this needs
to be done first to allow the full features of PROFINET IO Device DTM's to be used.
Apart from the configuration of OMRON PROFINET IO Devices by a DTM,
OMRON provides the possibility to use GSDML files to allow configuration of
third-party PROFINET IO Device Units, if a DTM is not provided.
To accommodate GSDML files in a FDT-container OMRON supplies a
PROFINET IO Generic Device DTM. The GSDML files of the PROFNET IO
Devices must be imported in CX-ConfiguratorFDT. The Generic device DTM
will recognize the GSDML files and make them available for configuration with
the PROFINET IO Controller.
The section Set-up using the GSDML file discusses the configuration of the
PROFINET IO CX-ConfiguratorFDT using this GSDML file.
Using the GSDML file for configuration allows the user to configure the
PROFINET IO Controller Unit for I/O data exchange with PROFINET IO
Devices. It does not, however, provide the acyclic messaging capabilities to
access parameters and status information in PROFINET IO Devices, such as
accessing the parameters in individual SmartSlice I/O Units. The GRT1-PNT
DTM does provide this capability.
For example: A GSDML file for the GRT1-PNT PROFINET IO Device is
available for download (GSDML-V2.1-OMRON-GRT1-PNT-20081205.xml)
through the OMRON Web site: http://technicalsupport.europe.omron.com/.
However, configuring with the DTM is the preferred method.
This section explains how to install the PROFINET IO Generic Device DTM
software.
1,2,3... 1 Exit all other Windows-based programs.
2 Double-click the file OMRON PNIOGenericDeviceDTM setup.exe.
The setup program for the PROFINET IO Generic Device DTM will start.
Section 3-5