Omron PROFINET IO CJ1W-PRM21 Operation Manual page 115

Configuring the IO Controller
Note
Re-allocating I/O Modules
The start address of Output area 1 in the example remains the same,
after adding an I/O module.
After setting up the initial I/O configuration, the I/O modules can be re-mapped
to the second Input/Output area. This can be accomplished by using drag &
drop to move the I/O modules. To accomplish this, perform the following
sequence:
1,2,3... 1 Open the CJ1W-PNT21 IO Controller DTM - Configuration User Interface.
2 Select the IO Device Area sub item. The window shows two sub tabs: One
for Output Allocation and one for Input Allocation. The following points
apply to each of these tabs.
Initial I/O Configuration
One I/O module of two output
words was inserted, and re-allocated
subsequent I/O modules.
Figure 7.14: Auto-addressing
Section 7-4
99