Table of Contents
Advertisement
When using the optional VGS-1 voice guide & storage unit, you gain access to the voice recorder and voice announcement functions.
VOICE ANNOUNCEMENTS
When changing modes, frequencies, settings, etc., an audio voice
will announce the new information.
•
Voice announcements are output from the PTT band side.
1 Enter Menu mode and access Menu 003.
2 Set the announcement function to MANUAL, AUTO, or OFF.
•
Refer to the tables below for announcements based on settings.
MANUAL:
A microphone PF key must be programmed as [VOICE] to
use MANUAL voice announcement.
Operation
While in VFO
Press [VOICE]:
mode
Operating band frequency
Press [VOICE]:
While in MR mode
"Channel" + Channel number +
operating band frequency
Press [VOICE]:
While in Call
"Call channel" + operating band
mode
frequency
Press [VOICE]:
While in Menu
Menu number or setting value
mode
(some selections have no voice
announcement)
Tone frequency
Press [VOICE]:
setup
"Tone frequency" + frequency value
CTCSS frequency
Press [VOICE]:
setup
"CTCSS frequency" + frequency value
Press [VOICE]:
DCS code setup
"DCS" + code value
"TX" + "TONE" or "DCS" + "RX" +
Cross tone setup
"TONE" or "CTCSS" or "DCS" or "OFF"
AUTO:
Announcements are made automatically when changing a
mode/frequency/setting.
Operation
Press [VFO]
"VFO"
Press [MR]
"MR"
Press [CALL]
"Call"
Press [MENU]
"Menu" + menu number
Press [F]
"Function"
Press [PM]
"PM"
Press [ENT]
"Enter"
VGS-1 (OPTIONAL) OPERATION
Announcement
Announcement
AUTO:
Announcements are made automatically when changing a
mode/frequency/setting.
Operation
Change the
operating band/
turn the power ON
Change the
frequency band
Setting up the PM
Frequency direct
entry
Memory Direct
Entry mode
Press [F], rotate
Tuning control
Press [F], [M.IN] in
VFO mode
Press [A/B] in
VFO mode
Press [F] and then
the Tuning control
in VFO mode
Select Menu
number in
category
Select setting
value in Menu
mode
Clearing a
memory channel
Perform a Full
Reset
Perform a Partial
Reset
Perform a VFO
Reset
Perform a PM
Reset
Press [LOCK]
(to turn the Lock
function ON)
Press [LOCK]
(to turn the Lock
function OFF)
Tone frequency
setup
VGS-1
Announcement
"A"/"B" + "Channel" (for MR only) +
"Call"/channel number + "Channel"
(for CALL only) + operating band
frequency + output power level + (PM
channel number (OFF, 1~5) (turn the
power ON))
New receive frequency
PM Channel number/"PM OFF"
Entered key number
Channel number
On stored channel
"Memory in" + channel number +
frequency
On blank channel
"Memory in" + channel number +
"Blank"
"A"/"B" + frequency + output power
level
"Menu" + "Mode" + The main Menu
number corresponds to the fi rst digit.
(For example, "5" is Menu No. 5xx.)
"Menu" + menu number
Setting value
"Memory" + "Channel"+ channel
number + "Clear"
"Full reset?"
"Partial reset?"
"VFO reset?"
"PM reset?"
"Lock on"
"Lock off"
"Tone frequency" + frequency value
Advertisement
Table of Contents
