Fluke 8846A Programmer's Manual page 66

8845A/8846A
Programmers Manual
DISPlay:TEXT(?) <quoted string >
Description Displays message on the Meter's display. This setting is stored in volatile
Meter must be remote before executing this command.
Parameters <quoted string> =
Examples
Query
DISPlay:TEXT:CLEar
Description Clears the displayed message on the Meter's display.
Examples
SYSTem:BEEPer
Description Causes the Meter to beep once.
Examples
SYSTem:BEEPer:STATe? <n>
Description Enables or disables the Meter's beeper. This setting is stored in volatile
Parameters <n>
Examples
Query
SYSTem:ERRor?
Description Retrieves errors from the Meter's error queue. Errors are retrieved in first-
Examples
SYSTem:ERRor:BEEPer(?) <n>
Description Enable or disables the Meter's beeper for error messages. This setting is
Parameters <n>
Examples
Query
58
memory.
DISP:TEXT "Hello"
DISP:TEXT?
DISP:CLE
SYST:BEEP
memory. Disabling the beeper causes the Meter to not beep for the
following conditions:
a new minimum or maximum is detected during statistics
a limit is exceeded during a limits test
a forward-biased diode is measured during a diode test
= ON or 1
OFF or 0
SYST:BEEP:STAT ON Enables the beeper.
SYST:BEEP:STAT?
in, first-out (FIFO) order. Each error may contain up to 80 characters.
SYST:ERR?
stored in volatile memory.
= ON or 1
OFF or 0
SYST:ERR:BEEP ON
SYST:ERR:BEEP?
Note
Up to 12 characters. Additional characters are
truncated.
Hello is displayed in the Meter's display.
Retrieves the text sent to the Meter in a
DISP:TEXT command.
Meter's display message is cleared.
Meter beeps.
Enables Meter's beeper.
Disables Meter's beeper.
Retrieves the state of the Meter's beeper ( 0 =
OFF and 1 = ON).
Returns error.
Enables beeper for error messages.
Disables beeper for error messages.
Set Meter to beep when errors are detected.
Returns state of beeper for error messages ( 0 =
OFF and 1 = ON).