8845A/8846A
Programmers Manual
A W Caution statement identifies conditions or practices that could result in damage to
the Meter or equipment to which it is connected.
To avoid electric shock, personal injury, or death, carefully read
the information under "Safety Information" before attempting to
install, use, or service the Meter.
Symbols
Table 1 is a list of safety and electrical symbols that appear on the Meter or in this
manual.
Symbol
W
X
B
F
D
or
C
R
Y
T
h
Local and Remote Operation
When the Meter is operated from a host, it is said to be operated remotely. When operated
from the front panel, it is said to be operated locally.
Most operations that can be performed locally can also be performed remotely over the
remote interface. Some operations, like setting communications parameters for the
RS-232 interface, and addressing the Meter for IEEE 488 operations can only be set
through the front panel.
To avoid electric shock, turn off the signal source to the Meter
before touching the test leads. The front panel display may not
indicate the true input voltage while in remote mode. Always
assume lethal voltages exist on the front-panel inputs.
2
Table 1. Safety and Electrical Symbols
Description
Risk of danger. Important
information. See manual
Hazardous voltage. Voltage > 30 V
dc or ac peak might be present
AC (Alternating Current)
DC (Direct Current)
AC or DC (Alternating or Direct
Current)
Continuity test or continuity beeper
tone
Potentially hazardous voltage
Double insulated
Static awareness. Static discharge
can damage part(s)
XW Warning
Symbol
O
Display ON / OFF
J
Earth ground
E
Capacitance
G
Diode
I
Fuse
Y
Digital signal
U
Maintenance or Service
CAT II
IEC 61010 Overvoltage (installation or
measurement) Category 2.
<
Recycle
~
Do not dispose of this product as unsorted
municipal waste. Go to Fluke's website for
recycle information.
XW Warning
Description