Skip Feed Printing - Gestetner 5499 User Manual

Skip Feed Printing

You can increase the time between
prints using the { { { { Skip Feed} } } } key. By
default, when one sheet of paper is
fed, the drum rotates twice. However,
you can select the number of drum ro-
tations. This gives you a chance to re-
move prints one by one from the
paper delivery tray or insert one sheet
of paper between two prints. If you
use this function, you can also use pa-
per longer than the length limitation
of 432mm, 17.0".
Note
❒ For every sheet of paper fed, the
drum rotates twice by default. You
can change this default setting
with the user tools. See "No. of
Skip Feed" on p.146 "4. Mode Set-
ting".
❒ The maximum length of paper in
Skip Feed mode is 460mm, 18.1".
❒ When you use paper longer than
432mm, 17.0", prints will not be de-
livered to the paper delivery tray
properly, so lower the paper deliv-
ery end plate and take out the
prints by hand.
A A A A
Place your original on the expo-
sure glass or in the optional docu-
ment feeder.
B B B B
Press the { { { { Skip Feed} } } } key.
Stamp
Make-Up
Over lay
Edge Erase
Skip Feed
Image Density
Lighter
On Line
Normal
Darker 1
Auto On Line
Darker 2
Economy Mode
Original Storage
Job Separator
ZDZS030N
C C C C
If necessary select the number of
drum rotations per sheet of paper
fed with the [← ← ← ← ] [→ → → → ] or { { { { ~ ~ ~ ~ } } } } { { { { } } } } } } } }
keys.
Note
❒ You can also select the number
of rotations with the number
keys.
❒ You can select from 2 to 9 rota-
tions.
❒ By default, the machine asks
you to confirm the number of
rotations. You can have this step
omitted by adjusting the user
tool settings. See "No. of Skip
Feed" on p.146 "4. Mode Set-
ting".
D D D D
Press the [OK] key.
E E E E
Press the { { { { Start} } } } key.
Skip Feed Printing
71
1