Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the display (see
To remove the power connector cable:
1.
Disconnect the power connector cable from the system board (1).
2.
Use a tool to disengage the connector from the computer (2), and then remove the power connector
cable (3).
Reverse this procedure to install the power connector cable.
Battery on page
32).
Optical drive on page
Bottom cover on page
Display assembly on page
33), if installed.
39).
62).
Component replacement procedures
Spare part number
814142-013
71
Advertisement
Table of Contents
