Connecting Other Devices; Connecting A Device Compatible With The Trigger Function; Connecting The Power Cable - Yamaha Aventage MusicCast RX-A1070BL Owner's Manual

5

Connecting other devices

Connect a device compatible with the trigger function.
Connecting a device compatible with the trigger
function
The trigger function can control an external device in conjunction with operating the unit (such
as powering on/off and input selection). If you have a Yamaha subwoofer that supports a
system connection or a device with a trigger input jack, you can use the trigger function by
connecting the external device to one of the TRIGGER OUT jacks with a monaural mini-plug
cable.
TRIGGER OUT 1-2 jacks
The unit (rear)
TRIGGER
OUT
HDMI (HDCP2.2) NETWORK
( 3 NET )
3 AV 4 AV 5 AV 6 AV 7
1
12V 0.1A
TRIGGER
OUT
MAX. TOTAL
1
REMOTE RS-232C
12V 0.1A
IN OUT
MAX. TOTAL 2
2
E OUT
(SINGLE)
1
2
ROUND SUR. BACK SUBWOOFER CENTER
SPEAKERS
EXTRA SP2 EXTRA SP1
R L R L CENTER R FRONT L
SURROUND BACK F.PRESENCE
SINGLE
ZONE 2 ZONE 2/BI-AMP
X
You can configure the trigger function settings in "Trigger Output1" and "Trigger Output2" (p.138) in the "Setup"
menu.
System connector
jack
Yamaha subwoofer that
supports a system connection
En
6

Connecting the power cable

Before connecting the power cable (Brazil and General models only)
Set the switch position of VOLTAGE SELECTOR according to your local voltage. Voltages are
AC 110–120/220–240 V, 50/60 Hz.
Y
Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC wall outlet.
Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a potential fire hazard.
NETWORK
( 3 NET )
AV 7
AC IN
GGER
OUT
REMOTE RS-232C
VOLTAGE SELECTOR
.1A
IN OUT
TAL
220V-
240V
110V-
120V
ERS
SP1
L CENTER R FRONT L
NCE
-AMP
After all the connections are complete, connect the supplied power cable to the unit and then
to an AC wall outlet.
The unit (rear)
NETWORK
( 3 NET )
AC IN
OTE RS-232C
OUT
CENTER R FRONT L
40
The unit (rear)
VOLTAGE SELECTOR
To an AC wall outlet