Yamaha Aventage MusicCast RX-A1070BL Owner's Manual page 124

■ Configuration
Configures the output characteristics of the speakers.
X
• When you configure the speaker size, select "Large" if the woofer diameter of your speaker is 16 cm (6-1/4") or
larger or "Small" if it is smaller than 16 cm (6-1/4") as a guide.
• When the speaker size is set to "Small", you can configure the "Crossover" setting after pressing ENTER.
Frequency sounds lower than the specified value will be output from the subwoofer and higher will be output
from the corresponding speakers.
Front
Selects the size of the front speakers.
Settings
Select this option for large speakers.
Large
The front speakers will produce all of the front channel frequency components.
Select this option for small speakers.
Small
The subwoofer will produce front channel low-frequency components lower than
the specified crossover frequency (default: 80 Hz).
X
"Front" is automatically set to "Large" when "Subwoofer" is set to "None".
Center
Selects whether or not a center speaker is connected and its size.
Settings
Select this option for large speakers.
Large
The center speaker will produce all of the center channel frequency components.
Select this option for small speakers.
Small
The subwoofer or front speakers will produce center channel low-frequency
components lower than the specified crossover frequency (default: 80 Hz).
Select this option when no center speaker is connected.
None
The front speakers will produce center channel audio.
Surround
Selects whether or not surround speakers are connected and their sizes.
Settings
Select this option for large speakers.
Large
The surround speakers will produce all of the surround channel frequency
components.
Select this option for small speakers.
Small
The subwoofer or front speakers will produce surround channel low-frequency
components lower than the specified crossover frequency (default: 80 Hz).
Select this option when no surround speakers are connected.
None
The front speakers will produce surround channel audio. Virtual CINEMA DSP
works when you select a sound program.
Surround Back
Selects whether or not surround back speakers are connected and their sizes.
Settings
Select this option when one large speaker is connected.
Large x1
The surround back speaker will produce all of the surround back channel
frequency components.
Select this option when two large speakers are connected.
Large x2
The surround back speakers will produce all of the surround back channel
frequency components.
Select this option when one small speaker is connected.
The subwoofer or front speakers will produce surround back channel
Small x1
low-frequency components lower than the specified crossover frequency
(default: 80 Hz).
Select this option when two small speakers are connected.
The subwoofer or front speakers will produce surround back channel
Small x2
low-frequency components lower than the specified crossover frequency
(default: 80 Hz).
Select this option when no surround back speakers are connected.
None
The surround speakers will produce surround back channel audio.
X
This setting is not available when "Surround" is set to "None", or when "Layout (Surround)" is set to "Front".
124
En