Listening To Fm/Am Radio (Except Australia, U.k., Europe And Russia Models); Setting The Frequency Steps; Selecting A Frequency For Reception - Yamaha Aventage MusicCast RX-A1070BL Owner's Manual

AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 PHONO PHONO
TUNER BLUETOOTH BLUETOOTH USB USB NET NET TUNER
MAIN MAIN ZONE 2 ZONE 2 PARTY PARTY HDMI OUT HDMI OUT
SCENE SCENE
1 1 2 2 3 3 4 4
MUTE MUTE
PROGRAM PROGRAM VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON ON
SCREEN SCREEN OPTION OPTION
ENTER ENTER
RETURN RETURN DISPLAY DISPLAY
BAND
BAND
MODE MODE
TUNING PRESET PRESET
TUNING
SUR. DECODE STRAIGHT SUR. DECODE STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER PURE DIRECT ENHANCER PURE DIRECT
INFO INFO SLEEP SLEEP
1 2 3 4
Numeric keys
5 6 7 8
9 0 MEMORY ENT

Listening to FM/AM radio (except Australia, U.K., Europe and Russia models)

You can tune into a radio station by specifying its frequency or selecting
from registered radio stations.
Y
• The radio frequencies differ depending on the country or region where the unit is
being used. The explanation of this section uses a display with frequencies used in
U.S.A. model.
• If you cannot obtain good reception on the radio, adjust the direction of the FM/AM
antennas.

Setting the frequency steps

(Brazil, Asia and General models only)
At the factory, the frequency step setting is set to 50 kHz for FM and 9 kHz
for AM. Depending on your country or region, set the frequency steps to
100 kHz for FM and 10 kHz for AM.
1
Set the unit to standby mode.
2
When holding down STRAIGHT on the front panel, press
MAIN ZONE z.
MAIN ZONE z
STRAIGHT
PROGRAM
3
Press PROGRAM repeatedly to select "TUNER FRQ STEP".
TUNER FRQ STEP
FM50/AM9
4
Press STRAIGHT to select "FM100/AM10".
5
Press MAIN ZONE z to set the unit to standby mode and
turn it on again.

Selecting a frequency for reception

1
Press TUNER to select "TUNER" as the input source.
2
Press BAND to select a band (FM or AM).
3
Use the following keys to set a frequency.
TUNING: Increase/decrease the frequency. Hold down the key for
about a second to search stations automatically.
Numeric keys: Enter a frequency directly. For example, to select
98.50 MHz, press "9", "8", "5" and "0" (or ENT).
"TUNED" lights up when a signal is received from a radio station.
"STEREO" also lights up when a stereo signal is received.
Y
"Wrong Station!" appears when you enter a frequency that is out of reception range.
X
You can switch between "Stereo" (stereo) and "Mono" (monaural) for FM radio
reception in "FM Mode" (p.110) in the "Option" menu. When the signal reception for an
FM radio station is unstable, switching to monaural may improve it.
69
En
FM 87.50MHz
VOL.
FM 98.50MHz
VOL.
STEREO TUNED L C R
SL SW
SBL SBR
SR