Boot Menu - Gateway Solo 5100 Maintaining & Troubleshooting

Note:
The Setup menu screen shown
may differ somewhat from
that shown here. If there are
differences, follow the on-
screen instructions and helps.
76 Maintaining and Troubleshooting Your Solo Notebook
Main Advanced Security Power Boot Exit
Power Switch:
Lid Switch:
Low Battery Beep:
Cooling Control:
> AC Mode Power Savings:
>DC Mode Power Savings:
Resume On Time:
Resume Time:
Resume On Modem Ring:
F1 Help Select Item -/+ Change Values
ESC Exits Select Menu
Power menu
Press the <Esc> key to access the Exit menu and accept or discard changes. Press
<F9> to return to the factory defaults, or <No> to return to the previous settings.
Use the right arrow key to move over to the next menu.

Boot menu

The Boot menu allows you to change the sequence of devices from which your
notebook is to boot.
1. Turn on your notebook.
2. Press the <F2> key when prompted to do so. The "Entering Setup..."
message briefly shows and then the Main menu appears.
3. Follow the instructions along the bottom of the menus to navigate through the
different options and menus. An Item Specific Help area providing additional
information is also located along the right side of each menu.
PhoenixBIOS Setup Utility
[On/Off]
[Backlight Off]
[Enabled]
[Performance]
[Off]
[00:00:00]
[Off]
F9 Setup Default
Enter Select > Sub-Menu F10 Save and Exit
To access the Setup menus
Item Specific Help