Gateway Solo 5100 Maintaining & Troubleshooting page 49

3. Highlight Audio Devices
4. In the
Add dialog box highlight
5. Type the default path of A:\, insert the Windows NT 4.0 Audio driver disk,
click .
OK
6. Click to highlight ES1879/1869/1878/1868/1887/1888 AudioDrive
7. A window appears stating that the driver has been installed and the system
needs to be restarted for changes to take effect. Remove the disk and click
Restart Now . If you are reinstalling the Windows NT operating system and
need to install additional drivers, you can click
continue installing the other drivers before restarting.
8. After rebooting, sounds should play when entering Windows NT. If you do
not hear sound, verify the volume settings in software and the volume level on
the volume wheel control on the left side of the system.
Installing CardWizard and PowerProfiler
CardWizard for Windows NT aids with PC Card configuration and PowerProfiler
for Windows NT handles power management issues. Your notebook has been
factory configured with CardWizard and PowerProfiler.
CardWizard and PowerProfiler programs are located on a three-disk set. Both
programs are installed through a single setup process. To reinstall CardWizard for
Windows NT insert the diskette into the appropriate drive and follow the on-screen
prompts. If you need assistance, refer to the following instructions.
Installing CardWizard & PowerProfiler software
1. If the floppy drive module is not already installed, shut down the system and
install the floppy drive. Restart Windows.
2. With Windows NT running, insert Windows NT 4.0 CardWizard Drivers
Disk 1of 3 in drive A:. Click
a:\setup
then Click .
OK
3. The SystemSoft logo appears with a window stating that the InstallShield
Wizard is being prepared. This may take a minute.
and then click Add .
Unlisted or Updated Driver
Don't Restart Now
Start , Run, and on the command line type:
and click OK .
. Click OK .
and
Chapter 4: Installing Drivers and Related Software 49