Chapter 3 Network Setup; Switcher Setup With A Windows Computer - Datavideo EPB-1340 Instruction Manual

Chapter 3
The Ethernet port on the back panel of the HS-1300 allows the user to import or export Stills/Clip files and
User memory using the Switcher Image Import/Export software. The Switcher Image Import/Export
software allows you to manipulate user memories, still pictures and clip files.
Section 3.1 discusses direct connection between the HS-1300 and your Windows computer. In Section 3.2,
we will show you how you can remotely set up the Switcher Image Import/Export software with your
switcher after it is installed on your Windows computer.

3.1 Switcher Setup with a Windows Computer

When new from the factory the HS-1300 will initially have a static IP address of 192.168.100.101. The
unit can be directly connected to a Windows-based computer using an RJ-45 ethernet cable. The following
set up should allow you to initially configure the unit before moving it to an existing DHCP / LAN network.
 An RJ-45 Ethernet cable.
 Windows 7/8/10 laptop or PC.
 The Datavideo Switcher Image
Import/Export software.
1. First connect the HS-1300 and the Windows computer together using an RJ-45 ethernet cable.
2. Turn on the Windows computer and set it to static IP setup within the Windows Network and Sharing
Centre. In our example below the computer is given the following IP settings so that the computer
matches the same IP range as the switcher.
3. Now install the Switcher Image Import/Export software to the computer.
Network Setup
Instructions
19