Outputs - Datavideo EPB-1340 Instruction Manual

Freeze
"Freeze" allows the user to load an image to Inputs 1-6 from one of the four sources listed as follows:
 Still
 Freeze
 Live
Crosspoint
In this sub-option, the user can shuffle the contents of Inputs 1-6 without changing the hardware
connections at the back of the machine, or even assign multiple inputs to the same source. For example,
the user is allowed to assign the input 2 video source to input 1, after which the input 2 video will also be
displayed on the input 1 window.

Outputs

This option allows the user to configure various output settings such as video output, audio output, and
GPI Out.
Advanced Mode
Outputs
Basic Mode
Outputs
Outputs
In general, the two SDI output ports (SDI 1 and SDI 2) located on the rear panel as well as the 17.3" built-in
monitor (HDMI) can be configured to output one of the following:
 Input 6
 Input 5
 Input 4
 Input 3
 Input 2
 Input 1
 CLN PVW (Clean PVW)
 CLN PGM (Clean PGM)
 PG + DSK
 PVW
 PGM
 MultiV (Multi view)
In addition to selecting your output source, you are also allowed to set two different resolutions for the
17.3" built-in monitor. The two available resolutions are 1080i and 1080p.
Output Sdi 1
Audio Mode
Sdi 1
Tally Mode Audio Mixer
GPI Out
MultiViewer AutoNum
Output Sdi 1
Audio Mode
Sdi 1
Pgm Sdi 2
On Src
On Sdi 2
Off Mode
Input 1 Delay
Off Label Inf
Pgm Sdi 2
On Src
On Sdi 2
36
Input 2 HDMI
Follow
On HDMI
Pulse Width
0
Off Trns Lab
Input 2 HDMI
Follow
On HDMI
1080P
On
1
Off
1080P
On