Finishing Requirements - Superior Fireplaces DRT63 Installation & Operation Instructions

Innovative Hearth Products
DRT63STTYN Power-Vent Direct-Vent Fireplaces

FINISHING REQUIREMENTS

Wall Details - INDOOR SIDE(S)
Complete the finished interior wall. To install the appliance facing flush
with the finished wall, position framework to accommodate the thickness
of the finished wall (Figure 51).
INTERIOR WALL FINISHING
Wall Stud
Combustible
Finished Wall
Materials
Header
Combustible
materials are
allowed on face
of appliance
above this point
*Insulation is
NOT ALLOWED in
clearance zones
around vent
components.
Keep this area free
from combustible
materials.
Figure 51
Min. 3"*
(77 mm)
Min. 1"*
(26 mm)
Adaptor plus
min. 4 feet
vertical vent
and 90˚ elbow
Top of
Appliance
Spacers
Top of Door Frame
FIREPLACE
(side view)
See Page 7 for Cold Climate Insulation
and Page 11 for Clearances
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Wall Details - OUTDOOR SIDE
Complete finished exterior wall per the instructions provided in the
Outdoor Installation Kit and the instructions provided here. To install the
appliance facing flush with the finished exterior wall, position framework
to accommodate the thickness of the exterior finished wall (Figure 52).
EXTERIOR WALL FINISHING
Min. 3"*
(77 mm)*
Adaptor plus
min. 4 feet
vertical vent
1"
and 90˚ elbow
(26 mm)
Minimum
Top of
Appliance
Spacers
Top of Door Frame
FIREPLACE
(side view)
Figure 52
Installation Instructions
900358-00, 01/2018
Wall Stud
Combustible
Sheathing
Header
Non-combustible
sheathing required
below this point
Non-combustible
Extend housewrap
(building paper)
to this point.
Note: Non-combustible
sheathing and
housewrap (building
paper) should extend
to U-channels on
sides and bottom.
*Insulation is
NOT ALLOWED in
clearance zones
around vent
components.
Keep this area free
from combustible
materials.
31