Table of Contents
Advertisement
Options
PPPoE Auto
Dialup
Connection
Status
Advanced PPTP
This Advanced PPTP screen is only useful if using the PPTP connection method.
•
Specified Fix IP Address – If you have a fixed IP address, enter if here.
Otherwise, this field should be left at 0.0.0.0.
•
Assigned Host Name –This field is used by a Host to uniquely associate
an access concentrator with a particular Host request.
•
Auto Dialup (connect-on-demand) – If set to Enable, a connection will be
established whenever outgoing WAN traffic is detected. If not enabled,
you must establish a connection manually.
•
Disconnect after Idle – This determines when an idle connection will be
terminated. Enter the required time period. (-1: Always on)
•
Echo Time – This determines how often an Echo request is sent to the
PPPoE server. The Echo request is used to determine if the connection is
still alive. Normally, there is no need to change the default value.
•
Echo Retry – The number of times the Echo request will be sent, if there
is no response to the first request. Normally, there is no need to change
the default value.
This displays the current connection status for each session.
Figure 3-4: Advanced PPTP
Page 25
Advertisement
Table of Contents
