Table of Contents
Advertisement
Ethernet Ports and Reset Button
WAN ports: 2 to 8 WAN ports (default is 2), using Port 1 to Port 8 for connecting
Ethernet Ports
to Modem(s).
LAN ports: The remaining ports which are connected to PCs or a Hub.
Note:
Any port will automatically operate as an "Uplink" port if required. You can use a
normal LAN cable to connect to a normal port on another hub.
Reset Button
When pressed and released, the Multi-WAN VPN Link Balancer will reboot
(restart) within 1 second. It will reset to default when pushed and held for more
than 3 seconds.
Some Status and Error conditions are indicated by the combinations of
LEDs, as shown below:
LED Action
Status – System & Packets flash alternatively.
Status – System & Packets flash concurrently.
Status – System (Solid Off) & Packets (Solid On)
Status – System (Solid On) & Packets (Solid On)
Condition
Firmware Download in progress.
MAC address not assigned.
SDRAM error
Timer/Interrupt error
Page 6
Advertisement
Table of Contents
