Table of Contents
Advertisement
The fields you can set are:
Software Update Mode Set to either Network or SLIP. Determines whether the configuration file
should be obtained through the Ethernet network or through the console port.
TFTP Server Address The IP address of the TFTP server where the configuration file is located. This
entry is used only if the Firmware Update is set to Enabled. If BOOTP Service (see the IP Configuration
screen under Configure IP Address on the System Configuration menu) is set to Enabled, the address
will be obtained from the BOOTP server.
Firmware Update Determines whether or not the Switch will try to look for a runtime image file over
the network. If set to Disabled, none of the fields below have any effect.
File Name The pathname of the runtime image file on your TFTP server to be downloaded.
Use Config File Toggle to Enabled to download config file during reboot.
File Name The name of the configuration file to be downloaded.
System Utilities
The Utilities menu features Ping Test, Save Settings to TFTP Server, Save Switch History to TFTP
Server, and Clear Address Table commands. Additionally, this menu allows you to enable or disable Web
management.
Choose System Utilities on the main menu to access the Utilities menu seen below:
Figure 6-44. Update Firmware and Configuration Files screen
57
Gigabit Ethernet Switch User's Guide
Advertisement
Table of Contents
