Table of Contents
Advertisement
To edit or delete a port-based VLAN, select Edit/Delete a Port-Based VLAN from the Configure VLAN
(Port-Based) screen. The following screen appears:
Select Edit or Delete in the Action field and then select a VLAN from the column on the right side of the
screen above. The following screen appears:
Toggle between Yes or No to assign a port to be a member of the selected VLAN. Press APPLY to let the
changes take effect.
Configure 802.1Q VLAN
To configure an IEEE 802.1Q VLAN, you must do three things:
1. Decide if you want to enable Ingress Filtering and enable it on the chosen ports. Ingress filtering applied
on a port causes the port to examine all incoming packets and check whether the port itself is a member of
the VLAN. This is normally used to keep untagged frames off the Switch, although it can have other uses
as well. This setting is configurable for each port in the Ingress Filtering screen.
Figure 6-34. first Edit/Delete a Port-based VLAN screen
Figure 6-35. second Edit/Delete a Port-based VLAN screen
51
Gigabit Ethernet Switch User's Guide
Advertisement
Table of Contents
