Table of Contents
Advertisement
Enabled only when the recording frame frequency of the [SYSTEM] menu → [REC FORMAT] is set to 59.94i/59.94p/29.97p.
[DF]
[NDF]
(Factory setting: [DF])
@
NOTE
t The setting is fixed to [NDF] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[UB MODE]
Sets user bits. User bits are recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.
[FRAME RATE]
[USER]
[TIME]
[DATE]
[TC]
[CLIP NAME]
(Factory setting: [USER])
[TC IN/OUT SEL]
Sets the input/output of the <TC IN/OUT> terminal.
[TC IN]
[TC OUT]
(Factory setting: [TC IN])
[TC OUT REF]
Sets the output delay of the time code that is output from the <TC IN/OUT> terminal.
[RECORDING]
[SDI OUT1]
(Factory setting: [RECORDING])
[REC COUNTER]
Sets operation of the counter for recording.
[TOTAL]
[CLIP]
(Factory setting: [TOTAL])
[NETWORK] menu
Specifies the network function settings.
[DEVICE SEL]
Select the device that connects external equipment (computer, etc.) to the camera.
The camera may restart when the setting is changed.
[LAN]
[WLAN]
[OFF]
(Factory setting: [OFF])
[NETWORK FUNC]
Selects the network function of the camera.
[STREAMING]
[NDI|HX]
[OFF]
(Factory setting: [OFF])
@
NOTE
t When [NDI|HX] is selected, recording and thumbnail display are not possible.
Chapter 4 Operation — Menu settings
Uses the drop frame mode.
Uses the non-drop frame mode.
Selects the image information (such as frame rate) of the camera.
Selects the set user bits.
Selects the local time. (hh, mm, ss)
Selects the local date and time. (YY, MM, DD, hh)
Records the time code value as user bits.
Records the value that CAM INDEX (one character) and CARD COUNT (three-digit number) are converted to ASCII
character code. Only enabled when the [SYSTEM] menu → [FILE FORMAT] → [MOV] is set.
Sets to the time code input.
Sets to the time code output.
Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras with
the time code of this camera as the master.
Matches to the output image from the <SDI OUT1> terminal. Outputs without delay when the image is not output from the
<SDI OUT1> terminal.
Performs continuous counting until it is reset by pressing the <RESET> button.
Clears the counter value at the start of recording and counts the time for each recording.
Connects via a wired LAN.
Connects via a wireless LAN.
Does not connect.
Enables the streaming function.
Enables the NDI|HX function.
Disables the network function.
– 97 –
Advertisement
Table of Contents
