Table of Contents
Advertisement
Loading the chromatic aberration compensation file from the SD card
CAMERA
EXIT
SCENE FILE
FILE
AUDIO
BATTERY
VIDEO OUT/LCD/VF
GENLOCK
RECORDING
COLOR BARS
NETWORK
LED
SYSTEM
CLOCK
OTHERS
GPS
1
Insert the SD card with the chromatic aberration compensation data that was downloaded from our website into the card slot of
the camera selected by the [OTHERS] menu → [FILE] → [SLOT FOR LOAD/SAVE].
For details on downloading, refer to the following website.
https://pro-av.panasonic.net/
2
Select the [OTHERS] menu → [FILE] → [CAC FILE(SD CARD)] → [LOAD]. (Fig. 1)
The list of CAC files on the SD card is displayed.
3
Select the file number to load. (Fig. 2)
The list of CAC files saved in camera memory is displayed.
4
Select the file number to save.
A confirmation screen is displayed.
5
Select [SET].
The CAC files are loaded to camera memory.
6
To store multiple chromatic aberration compensation data in the camera, repeat steps 2 to 5.
7
Press the <MENU> button to close the menu.
The menu is cleared and returns to the camera status display.
@
NOTE
t Up to 32 files can be loaded to the camera.
To load a new file, delete any file before loading the new file.
Deleting the chromatic aberration compensation file from the camera
1
Set to the [CAMERA] menu → [CAC ADJ.] → [CAC CONTROL] → [OFF].
2
Select the lens model number to delete with [LIST/DELETE].
A confirmation screen is displayed.
3
Select [SET].
The file is deleted.
When the chromatic aberration compensation data is not functioning properly
When the chromatic aberration compensation function is not functioning properly, or when the chromatic aberration compensation data is not loaded
normally, an error message is displayed on the viewfinder.
Error message
[CAC FILE DATA NOT FOUND]
[CAC LENS DATA INVALID]
[LENS INITIALIZATION NOT
COMPLETED]
@
NOTE
t When mounting lens optical system accessories (converter lens attachments), the chromatic aberration compensation function sometimes does not
function properly since the optical characteristics of the lens change. In this case, set the chromatic aberration compensation function to [OFF].
t When a focus servo is used on CANON lenses, enable recording after initialization is completed in the automatic initialization mode. Data is
sometimes recording while the focus ring is moving.
Chapter 3 Preparation — Mounting and adjusting the lens
EXIT
EXIT
SCENE FILE(SD CARD)
LOAD
DELETE
SETUP FILE(SD CARD)
SETUP FILE(MEMORY)
CAC FILE(SD CARD)
LENS FILE(SD CARD)
LENS FILE(MEMORY)
SLOT FOR LOAD/SAVE
Fig. 1
There is no chromatic aberration compensation data
matching the connected lens when the chromatic
aberration compensation function is enabled.
This is displayed when the camera is turned on.
The response data from the lens is not supported, or the
response contains information other than that defined in
the chromatic aberration compensation data.
Position detection (focus zoom) of the lens is encoder
type, and initialization is not completed.
MENU>OTHERS>FILE>CAC FILE(SD CARD)>LOAD
1
CJ12ex4.3B IASE S
UA22X8 0BERD-S8
2
Meaning
– 41 –
Fig. 2
Remedy
Load chromatic aberration compensation data matching
the connected lens to the camera.
The lens is not a lens compatible with the chromatic
aberration compensation function.
The chromatic aberration compensation will not function,
but will not cause any problems in use.
Turn the focus/zoom ring to pass through the center of
the operating range.
2/2
Advertisement
Table of Contents
