Kyocera 1102H03NL0 Advanced Operation Manual page 244

System Menu
Low Power Timer
Auto Sleep
6-74
3
Press [+] or [–] to
enter the time until
Auto Panel Reset is
turned on.
You cannot use the
number keypad to
enter this value.
4
Press [OK].
You can specify the amount of time to wait before Low Power Mode.
Specify a value from 1 - 240 minutes (1 minute increments).
For more information on Low Power Mode, refer to the Operation Guide .
Use the procedure below to set the Low Power Mode.
1
Press the System Menu key.
2 Press [ ], [Date/Timer] and then [Low Power Timer].
3 Press [+],[–] or the numeric keys to enter the time until Low Power Mode is
turned on.
4 Press [OK].
If no job runs for a certain period of time, automatically enter Sleep Mode.
Refer to the Operation Guide for Sleep Mode.
Auto Sleep ON/OFF
Select whether to use Auto Sleep or not.
NOTE:
Time remaining before Auto Sleep can be modified as necessary.
Refer to Sleep Timer below about the procedures.
Use the procedure below to select the interface.
1
Press the System Menu key.
2
Press [ ], [Date/Timer] and then [Change] of Auto Sleep.
Date/Timer - Reset Timer
Set the amount of time to wait before automatic panel reset .
Use [-]/[+] to enter a number.
(5 - 495)
sec.
Status
ADVANCED OPERATION GUIDE
Cancel OK
10/10/2007 10 :10