Introduction - Rinnai DO-SC18Z91 Operation & Installation Manual

1. INTRODUCTION

MANDATORY INSPECTION PRIOR TO INSTALLATION
Immediately report any damage or discrepancies to the Supplier of the appliance. This appliance
IMPORTANT
was inspected and tested at the time of manufacture and packaging, and released for transportation
without known damage. Upon receipt, inspect the exterior for evidence of rough handling in shipment.
Ensure that the appliance is labelled correctly for the gas and electrical supply, and/or other services it
is intended to be connected to.
For safety and warranty purposes, appliances that may be damaged or incorrect MUST NOT be
installed or operated under any circumstances. Installation of damaged or incorrect appliances may
contravene local government regulations. Rinnai disclaims any liability or responsibility whatsoever in
relation to the installation or operation of damaged or incorrect appliances.
MICROCHANNEL COIL SAFETY – HANDLING THE APPLIANCE
This Brivis ICE appliance is fitted with an aluminium microchannel coil that is light in weight
IMPORTANT
and structurally robust. However, the coil refrigerant tubes are thin and exposed to the outer
face of the coil so extreme care must be taken when handling the appliance.
DO NOT lift or manoeuvre the appliance from the liquid or suction line tubes exiting the cabinet
wall as this may lead to premature coil failure and will result in coil replacement.
Read all instructions before proceeding with the installation and start up.
•
This equipment must be installed in accordance with all relevant regulatory authority and industry requirements.
•
Only qualified, licensed technicians shall perform works on these units; failure to do so will result in warranty
being void.
Definitions
Shall
"Shall" indicates a mandatory requirement of this manual
Should
"Should" indicates a recommended requirement of this manual
Any deviation from these instructions, may at the discretion of the manufacturer, void the warranty. As a result, the
customer and/or installer may be charged a fee for non-product warranty related call outs, Also note that failure to
comply with these instructions may preclude company service personnel from being able to service the appliance.
Disclaimer
This document is a guide only. Laws, regulations and industry standards can vary between
States and Territories.
IMPORTANT
Accordingly, this guide must be read in conjunction with, and subject to, all laws, regulations
and industry standards applicable in the State or Territory in which the products are installed.
You must ensure that the installation of the products will comply with those laws, regulations
and standards, and that the products recommended to customers are fit for the purpose for
which they are intended.
THE USER SHOULD RETAIN THIS MANUAL FOR FUTURE REFERENCE.
Brivis 32 ICE Fixed Speed OIM