Connecting And Configuring Your Router - Belkin F5D7234-4 User Manual

F5D7234-4 v4 Wireless G Router User Manual Rev1
Page 11 of 61
Connect your wired (non-wireless) computers to these ports. These ports are
RJ45, 10/100 auto-negotiation, auto-uplinking ports for standard UTP
category 5 or 6 Ethernet cable. The ports are labeled 1 through 4.
. Power Jack
J.
Connect the included 9V/1A DC power supply to this jack.
Reset Button
K.
The "Reset" button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router's normal operation
while maintaining the programmed settings. You can also restore the factory
default settings by using the "Reset" button. Use the restore option in
instances where you may have forgotten your login password.
a. Resetting the Router
Push and release the "Reset" button. The lights on the Router will momentarily
flash. The "router" light will begin to blink. When the "router" light becomes solid
again, the reset is complete.
b. Restoring the Factory Defaults
Press and hold the "Reset" button for at least 10 seconds, then release it. The
lights on the Router will momentarily flash. The "router" light will begin to blink.
When the "router" light becomes solid again, the reset is complete.

Connecting and Configuring your Router

Verify the contents of your box. You should have the following:
• Belkin G Wireless Router
• Quick Installation Guide
• Belkin Setup Assistant Software CD with User Manual
• RJ45 Ethernet Networking Cable (for connection of the Router to the modem)
• Power Supply
Modem Requirements
Your cable or DSL modem must be equipped with an RJ45 Ethernet port. Many
modems have both an RJ45 Ethernet port and a USB connection. If you have a
modem with both Ethernet and USB, and are using the USB connection at this
time, you will be instructed to use the RJ45 Ethernet port during the installation
procedure. If your modem has only a USB port, you can request a different type