Connecting And Configuring Your Router - Belkin F5D8233 User Manual

16030_P75445-A_F5D8233-4_V3000_N_RTR_MNL_961008.doc
Page 12 of 108
J. Reset Button – Red
The "Reset" button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router's normal operation
while maintaining the programmed settings. You can also restore the
factory default settings by using the "Reset" button. Use the restore option
in instances where you may have forgotten your custom password.
i. Resetting the Router
Push and release the "Reset" button. The lights on the Router
will momentarily flash. The "Power/Ready" light will begin to
blink. When the "Power/Ready" light becomes solid again, the
reset is complete.
ii. Restoring the Factory Defaults
Press and hold the "Reset" button for at least 10 seconds,
then release it. The lights on the Router will momentarily flash.
The "Power/Ready" light will begin to blink. When the
"Power/Ready" light becomes solid again, the restore is
complete.
K. Power Jack – Black
Connect the included 12V/1A DC power supply to this jack.
---------------------------------------------------------------------------------------------

Connecting and Configuring your Router

Verify the contents of your box. You should have the following:
• Belkin N Wireless Router
• RJ45 Ethernet Networking Cable
• Power Supply
• Belkin Setup Assistant Software CD
• User Manual on the Setup Assistant CD
• Network Status Display Guide
• Wireless Security Setup Guide
Modem Requirements
Your cable or DSL modem must be equipped with an RJ45 Ethernet port.
Many modems have both an RJ45 Ethernet port and a USB connection. If
you have a modem with both Ethernet and USB, and are using the USB