Belkin F5D7234-4 User Manual page 14

F5D7234-4 v4 Wireless G Router User Manual Rev1
Page 14 of 61
2.5 Configuring the Router
The Setup Assistant will now configure your Router by sending data to the
Router and restarting it. Wait for the on-screen instructions.
Note: Do not disconnect any cable or power off the Router while the Router is
rebooting. Doing so will render your Router inoperable.
2.6 Checking Internet Connection
We are almost done. The Setup Assistant will now check your connection to the
Internet.
Congratulations
You have finished installing your new Belkin Router. You will see the
Congratulations screen when your Router can connect to the Internet. You can
begin surfing by opening your browser and going to any website.
You can use the Setup Assistant to set up your other wired and wireless
computers to connect to the Internet by clicking "Next". If you decide to add
computers to your Router later, select "Finish—return to Main Menu" and then
click "Next".
Troubleshooting
If the Setup Assistant is not able to connect to the Internet, you will see the
following screen. Follow the on-screen instructions to go through the
troubleshooting steps.
2.7 Optional: Assistance Connecting Other Computers
This optional step will help you to connect additional wired and wireless
computers to your network. Follow the on-screen instructions.
Once you have verified that your other wired and wireless computers are
properly connected, your network is set up and working. You can now surf the
Internet. Click "Next" to return to the main menu.
Step 3: Set Up Wireless Security – Run the Security Assistant Software
Now that your network is set up and working, it is recommended that you turn on
wireless security to prevent unauthorized access to your network from
neighboring wireless-enabled computers. The Security Assistant will guide you
through the process. Click "Security Assistant" and follow the on-screen
instructions.