Connecting And Configuring Your Router - Belkin F5D8235-4 User Manual

PM00736-A_F5D8235-4_N+_RTR_MNL_jdk.doc
Page 12 of 120
K. Connections to Wired Computers (insert N+ Wireless Router Wired
Computer icon) – Gray
Connect your wired (non-wireless) computers to these ports. These ports are
RJ45, 10/100/1000 auto-negotiation, auto-uplinking ports for standard UTP
category 5 or 6 Ethernet cable. The ports are labeled 1 through 4.
L. USB Port
Plug in your USB storage device here.
M. Connection to Modem (insert N+ Wireless Router Modem icon) – Yellow
This port is for connection to your cable or DSL modem. Use the cable that was
provided with the modem to connect the modem to this port. Use of a cable other
than the one supplied with the cable modem may not work properly.
N. Reset Button
The "Reset" button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router's normal operation while
maintaining the programmed settings. You can also restore the factory default
settings by using the "Reset" button. Use the restore option in instances where
you may have forgotten your custom password.
i. Resetting the Router
Push and release the "Reset" button. The lights on the Router will
momentarily flash. The "Power/Ready" light will begin to blink. When
the "Power/Ready" light becomes solid again, the reset is complete.
ii. Restoring the Factory Defaults
Press and hold the "Reset" button for at least 10 seconds, then
release it. The lights on the Router will momentarily flash. The
"Power/Ready" light will begin to blink. When the "Power/Ready"
light becomes solid again, the restore is complete.
O. Power Jack – Black
Connect the included 12V/1.5A DC power supply to this jack.
---------------------------------------------------------------------------------------------

Connecting and Configuring your Router

Verify the contents of your box. You should have the following: