Hardware Installation; Rear Panel; Front Panel Leds - ZyXEL Communications ZyXEL Prestige 334 Quick Start Manual

2 Hardware Installation

2.1 Rear Panel

LABEL
LAN 10/100M
WAN 10/100M
POWER 9 VAC
After you've made the connections, connect the power cable to a power supply and look at the front panel LEDs.
RESET

2.2 Front Panel LEDs

The PWR LED blinks while performing system testing and then stays on if the testing is successful. The
LAN, and WAN LEDs turn on if they are properly connected.
LED STATUS
PWR
Amber
Use an Ethernet cable to connect at least one computer for initial Prestige configuration. These
ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically
adjust to the type of Ethernet cable you use (straight-through or crossover)).
Connect your cable/DSL modem to this port with the cable that came with your modem.
Connect the end of the included power adaptor (use only this adapter) to this power socket.
You only need to use this button if you've forgotten the Prestige's password. It returns the
Prestige to the factory defaults (password is 1234, LAN IP address 192.168.1.1. See your User's
Guide for details).
COLOR
Off The Prestige is not receiving power.
On Power to the Prestige is too low
P334 ENGLISH
DESCRIPTION
3
DESCRIPTION