System Log Windows; Hardware Installation; G-6000 Office Test; Figure 4-6 System Log - ZyXEL Communications G-6000 Quick Start Manual

High speed, long range ethernet wireless bridge

Table of Contents

To enable firmware updates:

Enter the host PC's IP address, User Name, Password, Image Path, and Image Name in the

data-entry files

2. Click Update Firmware to store the new firmware changes.

Note: The red reminder s only appear if you update setting in Configuration/System Setup page.

4.3.3

System Log Windows

The System Log window logs system events for detail descriptions of system status log. This is very useful to

track system. It shows important successful states and critical system logs.

If you didn't specify SNTP/NTP server IP address in Configuration/System Setup page, there won't be any

timestamp in system log. The following lists all system logs in G-6000.

Watch dog reboots system.

Firmware programming failed.

Error while saving configuration parameters.

5.1.

It is recommended that you test the system in office before you r outdoor installation. Please be noticed that

the power for each unit should be set as "min" at the first time for your system link with antennas connected

to the units. After you access the web page and read the RSSI value, the reading should be in the range

between –45 to –61. The physical cable connection of theG-6000 for office test is shown as the following

diagram:

Table of Contents